Tag: properties and uses of different radiation

Electromagnetic radiation is classified into types according to the frequency of the wave. These types include, in order of increasing frequency, radio waves, microwaves, infrared radiation, visible light, ultraviolet radiation, X-rays and gamma rays.
The frequency is the inverse of wavelength. Hence, in the order of increasing wavelength, the waves are Gamma rays ($<1nm$), X-rays ($1-10nm$), infra red rays ($700-{ 10 }^{ 5 }nm$), micro waves (${ 10 }^{ 5 }-{ 10 }^{ 8 }nm$), radio waves (${ >10 }^{ 8 }nm$).
Therefore, X-rays has a wavelength of $50 \mathring{A}$.

Microwaves are a form of electromagnetic radiation with wavelengths ranging from as long as one meter to as short as one millimeter; with frequencies between 300 MHz (0.3 GHz) and 300 GHz. This broad definition includes both UHF and EHF (millimeter waves), and various sources use different boundaries. 
Microwave technology is extensively used for point-to-point telecommunications (i.e. non-broadcast uses). Microwaves are especially suitable for this use since they are more easily focused into narrower beams than radio waves, allowing frequency reuse; their comparatively higher frequencies allow broad bandwidth and high data transmission rates, and antenna sizes are smaller than at lower frequencies because antenna size is inversely proportional to transmitted frequency. Microwaves are used in spacecraft communication, and much of the world's data, TV, and telephone communications are transmitted long distances by microwaves between ground stations and communications satellites.

X-rays is a form of electromagnetic radiation. Most X-rays have a wavelength ranging from $0.01$ to $10$ nanometers, corresponding to frequencies in the range 30 petahertz to 30 exahertz (${ { 3\times 10 }^{ 16 }\ Hz\ to\ 3\times 10 }^{ 19 }Hz$) and energies in the range 100 eV to 100 keV.
Hence, the rays or waves of $0.1 nm$ is X-rays.

Johann Ritter decided to place silver chloride in the area just beyond the violet end of the spectrum, in a region where no sunlight was visible. To his amazement, he saw that the silver chloride displayed an intense reaction well beyond the violet end of the spectrum, where no visible light could be seen. This showed for the first time that an invisible form of light existed beyond the violet end of the spectrum. This new type of light, which Ritter called Chemical Rays, later became known as ultraviolet light or ultraviolet radiation (the word ultra means beyond).
Hence, the radiation which can be detected by a solution of silver chloride is Ultraviolet radiation.

Gamma rays are the most energetic light waves found on the electromagnetic spectrum.

Point contact diodes, commonly called crystals, are the oldest microwave semiconductor devices. Unlike the pn-junction diode, the point-contact diode depends on the pressure of contact between a point and a semiconductor crystal for its operation.One section of the diode consists of a small rectangular crystal of n-type silicon. A fine beryllium-copper, bronze-phosphor, or tungsten wire presses against the crystal and forms the other part of the diode During the manufacture of the point contact diode, a relatively large current is passed from the the wire to the silicon crystal. The result of this large current is the formation of a small region of p-type material around the crystal in the vicinity of the point contact. Thus, a pn-junction is formed which behaves in the same way as a normal pn-junction. The pointed wire is used instead of a flat metal plate to produce a high-intensity electric field at the point contact without using a large external source voltage.

Magnetic resonance imaging (MRI) is a technique that uses a magnetic field and radio waves to create detailed images of the organs and tissues within your body.

Most MRI machines are large, tube-shaped magnets. When you lie inside an MRI machine, the magnetic field temporarily realigns hydrogen atoms in your body. Radio waves cause these aligned atoms to produce very faint signals, which are used to create cross-sectional MRI images like slices in a loaf of bread.

The frequency of television signal is smaller than that of microwave and visible waves.

$Answer:-$ A option

$Answer:-$ C and D option