Multiple choice

Refer to the exhibit. A network administrator is attempting to configure a Frame Relay network. The administrator enters the commands as shown in the exhibit on R2 but the Frame Relay PVCs are inactive. What is the problem?

  1. The incorrect DLCI numbers are being configured on R2.

  2. The S0/0/0 interface on R2 needs to be point-to-point.

  3. The frame-relay map commands are missing the cisco keyword at the end.

  4. A single router interface cannot connect to more than one Frame Relay peer at a time.
Reveal answer Fill a bubble to check yourself
A Correct answer
Explanation

The question states the administrator enters commands and Frame Relay PVCs are inactive. Without seeing the exhibit, the claimed answer is A (incorrect DLCI numbers). This is plausible because mismatched or wrong DLCI numbers would prevent PVCs from becoming active. The other options (interface needs to be point-to-point, missing cisco keyword, single router limitation) are less likely to cause the described issue.

Keep practicing — related questions