Home › Quizzes › Network Redundancy

Network Redundancy

This quiz will test your understanding of Network Redundancy.

15 Questions Published
Play Quiz Practise this topic out loud

Questions

Question 1 Multiple Choice (Single Answer)

What is the primary purpose of network redundancy?

  1. To increase network speed
  2. To reduce network latency
  3. To provide backup paths in case of failure
  4. To improve network security
Question 2 Multiple Choice (Single Answer)

Which of the following is NOT a common type of network redundancy?

  1. Active-active redundancy
  2. Active-passive redundancy
  3. Load balancing
  4. Spanning Tree Protocol
Question 3 Multiple Choice (Single Answer)

In active-active redundancy, how many devices are typically used?

  1. 1
  2. 2
  3. 3
  4. 4
Question 4 Multiple Choice (Single Answer)

What is the main advantage of active-active redundancy over active-passive redundancy?

  1. Increased bandwidth
  2. Improved fault tolerance
  3. Lower cost
  4. Simplified management
Question 5 Multiple Choice (Single Answer)

Which of the following is NOT a benefit of network redundancy?

  1. Increased reliability
  2. Improved performance
  3. Reduced downtime
  4. Increased cost
Question 6 Multiple Choice (Single Answer)

What is the term for a network topology that uses multiple paths between devices?

  1. Star topology
  2. Bus topology
  3. Ring topology
  4. Mesh topology
Question 7 Multiple Choice (Single Answer)

Which of the following is NOT a common redundancy protocol used in networks?

  1. Hot standby routing protocol (HSRP)
  2. Virtual Router Redundancy Protocol (VRRP)
  3. Gateway Load Balancing Protocol (GLBP)
  4. Transmission Control Protocol (TCP)
Question 8 Multiple Choice (Single Answer)

What is the purpose of load balancing in network redundancy?

  1. To increase network speed
  2. To reduce network latency
  3. To distribute traffic across multiple paths
  4. To improve network security
Question 9 Multiple Choice (Single Answer)

Which of the following is NOT a common load balancing algorithm?

  1. Round-robin
  2. Least connections
  3. Weighted round-robin
  4. First-come, first-served
Question 10 Multiple Choice (Single Answer)

What is the term for a network device that is used to connect two or more networks?

  1. Router
  2. Switch
  3. Hub
  4. Modem
Question 11 Multiple Choice (Single Answer)

Which of the following is NOT a common type of router redundancy?

  1. Hot standby routing protocol (HSRP)
  2. Virtual Router Redundancy Protocol (VRRP)
  3. Gateway Load Balancing Protocol (GLBP)
  4. Spanning Tree Protocol
Question 12 Multiple Choice (Single Answer)

What is the purpose of a spanning tree protocol in network redundancy?

  1. To prevent loops in a network
  2. To distribute traffic across multiple paths
  3. To provide backup paths in case of failure
  4. To improve network security
Question 13 Multiple Choice (Single Answer)

Which of the following is NOT a common spanning tree protocol?

  1. Spanning Tree Protocol (STP)
  2. Rapid Spanning Tree Protocol (RSTP)
  3. Multiple Spanning Tree Protocol (MSTP)
  4. VLAN Trunking Protocol (VTP)
Question 14 Multiple Choice (Single Answer)

What is the term for a network device that is used to connect multiple devices to a network?

  1. Router
  2. Switch
  3. Hub
  4. Modem
Question 15 Multiple Choice (Single Answer)

Which of the following is NOT a common type of switch redundancy?

  1. Hot standby switch redundancy
  2. Virtual Switch Redundancy Protocol (VSRP)
  3. Link Aggregation Control Protocol (LACP)
  4. Spanning Tree Protocol
← Back to Quizzes